Configuring A Server Behind Nat; Figure 151 Menu 15.2 Nat Server Setup - ZyXEL Communications Prestige 2602R Series User Manual

Menu 15.1.1.1 Editing/Configuring an Individual Rule in a Set
Table 93
FIELD
End
Global IP
Start
End
Server
Mapping Set
When you have completed this menu, press [ENTER] at the prompt "
or ESC to Cancel:

28.4 Configuring a Server Behind NAT

Follow these steps to configure a server behind NAT:
1 Enter 15 in the main menu to go to Menu 15 - NAT Setup.
2 Enter 2 to display Menu 15.2 - NAT Server Sets as shown next.

Figure 151 Menu 15.2 NAT Server Setup

3 Enter 1 to go to Menu 15.2 NAT Server Setup as follows.
Chapter 28 Network Address Translation (NAT)
DESCRIPTION
This is the ending local IP address (ILA). If the rule is for all local IPs, then put the Start
IP as 0.0.0.0 and the End IP as 255.255.255.255. This field is N/A for One-to-One and
Server types.
This is the starting inside global IP address (IGA). If you have a dynamic IP, enter
0.0.0.0 as the Global IP Start. Note that Global IP Start can be set to 0.0.0.0 only if
the types are Many-to-One or Server.
This is the ending inside global IP address (IGA). This field is N/A for One-to-One,
Many-to-One and Server types.
Only available when Type is set to Server. Type a number from 1 to 10 to choose a
server set from menu 15.2.
" to save your configuration, or press [ESC] at any time to cancel.
Menu 15.2 - NAT Server Sets
1. Server Set 1 (Used for SUA Only)
2. Server Set 2
3. Server Set 3
4. Server Set 4
5. Server Set 5
6. Server Set 6
7. Server Set 7
8. Server Set 8
9. Server Set 9
10. Server Set 10
Enter Set Number to Edit:
Prestige 2602R Series User's Guide
(continued)
Press ENTER to Confirm
273