Table of Contents
Advertisement
7C1-12 CLUTCH
Clutch disc
Measure depth of rivet head depression, i.e. distance between
rivet head and facing surface. If depression is found to have
reached service limit at any of holes, replace disc assembly.
Rivet head depth
Standard : 1.65 – 2.25 mm (0.06 – 0.09 in.)
Service limit : 0.5 mm (0.02 in.)
Clutch cover
1) Check diaphragm spring (1) for abnormal wear or damage.
2) Inspect pressure plate (2) for wear or heat spots.
3) If abnormality is found, replace clutch cover. Do not disas-
semble it into diaphragm spring and pressure plate (2).
Flywheel
Check surface contacting clutch disc for abnormal wear or heat
spots. Replace or repair as required.
Clutch Release Mechanism Removal and
Installation
Removal
1) Remove release lever by loosening its bolt.
2) Take out release bearing by turning release shaft (1).
3) Unhook return spring (2) using pliers.
4) Drive out No.2 bush using special tool and hammer.
Release shaft seal will also be pushed out.
Special tool
(A) : 09922-46010
5) Remove release shaft (1) and return spring (2).
Advertisement
Table of Contents
