Suzuki Ignis Service Manual page 3691

7D-24 TRANSFER
Bevel gear tooth contact table
TOOTH CONTACT PATTERN DIAGNOSIS AND REMEDY
NORMAL
HIGH CONTACT
Pinion is positioned too fat from the
center of drive bevel gear.
1) Decrease thickness of bevel pinion
shim and position pinion closer to
gear center.
2) Adjust drive bevel gear backlash to
specification referring to "Bevel
Gear Back Lash Measurement and
Adjustment" in this section.
LOW CONTACT
Pinion is positioned too close to the
center of drive bevel gear.
1) Increase thickness of bevel pinion
shim and position pinion farther
from gear center.
2) Adjust drive bevel gear backlash to
specification referring to "Bevel
Gear Back Lash Measurement and
Adjustment" in this section.
These contact patterns indicate that the "offset" of
reduction driven gear is too much or too little. The rem-
edy is to change the division of the bevel gear shim(s).