Table of Contents
Advertisement
1
WARNING:
Handling of Rearend Door Balancer (Damper)
• Do not disassemble balancer (1) because its cylinder
is filled with gas.
• Handle balancer carefully. Do not scar or scratch
exposed surface of its piston rod, and never allow any
paint or oil to stick to its surface.
• Do not turn piston rod with balancer fully extended.
• When discarding removed rearend door balancer
(damper), use a 2 – 3 mm (0.08 – 0.12 in.) drill (2) to
make a hole as shown.
• The gas itself is harmless but it may issue out of the
hole together with chips generated by the drill (2).
Therefore, be sure to wear goggle.
INSTALLATION
Reverse removal procedure to install rearend door noting the fol-
lowing instructions.
• Secure wiring harness (1).
• Apply sealant to contact face "A" of door hinge (1).
"A": Sealant 99000-31110
• Apply grease to rotating part "B" of hinge (1).
"B": Lithium grease 99000-25010
• Adjust door latch striker position by referring "Rearend Door
Removal and Installation" in this section.
• Adjust door cushion so that door becomes flush with body.
• Adjust door clearance by loosening door hinge mounting
bolts and nuts referring to "Panel Clearance" in this section.
BODY SERVICE 9-27
Advertisement
Table of Contents
