Table of Contents
Advertisement
1
1
1
3, (a)
3) Connect side sensor connector pushing connector inner (1)
as shown.
4) Connect negative cable at battery.
5) Enable air bag system. Refer to "Enabling air bag system" in
this section.
Side Sensor Inspection
CAUTION:
• Never disassemble side sensor.
• Sensor should be replaced when it was dropped from a
height of 90 cm (3 ft) or more.
• Check sensor (1) for dents, crack, deformation.
• Check sensor connector (sensor side and harness side),
lock mechanism or sensor lead wire for damage, crack,
scorching or melting.
• Check connector terminals for bent, corrosion or rust.
If any faulty condition is found in above checks, replace.
2
Seat Belt Pretensioner Removal and Installa-
tion
Refer to "Front Seat Belt Removal and Installation" in Section 10.
Seat Belt Pretensioner Inspection
Refer to "Rear Seat Belt Inspection" in Section 10.
AIR BAG SYSTEM 10B-75
Advertisement
Table of Contents
