Table of Contents
Advertisement
6A1-28 ENGINE MECHANICAL (M13 ENGINE)
2
1
4) Install new O-rings (2) in the position as shown in figure and
Tightening torque
Oil pump strainer bolt (a) : 11 N·m (1.1 kg-m, 8.0 lb-ft)
Oil pump strainer bracket bolt
(b) : 11 N·m (1.1 kg-m, 8.0 lb-ft)
5) After fitting oil pan to cylinder block, run in securing bolts and
Tightening torque
Oil pan bolts and nuts (a) : 11 N·m (1.1 kg-m, 8.0 lb-ft)
6) Install new gasket and drain plug to oil pan.
Tightening torque
Oil pan drain plug bolt (b) : 50 N·m (5.0 kg-m, 36.5 lb-ft)
7) For 2WD vehicle, install Engine rear mounting bracket.
8) For 4WD vehicle, install transfer referring to "Transfer Dis-
9) Install transaxle stiffener (3).
(a)
(b)
Tightening torque
Transaxle stiffener bolts (c and d) :
50 N·m (5.0 kg-m, 36.5 lb-ft)
2
(d)
10) Install exhaust manifold stiffener (2) and exhaust No.1 pipe
3
(c)
Tightening torque
Exhaust No.1 pipe bolts (a) : 50 N·m (5.0 kg-m, 36.5 lb-ft)
Exhaust manifold stiffener bolts (b) :
50 N·m (5.0 kg-m, 36.5 lb-ft)
11) Install oil level gauge.
12) Refill engine with engine oil referring to "Engine Oil and Oil
13) Verify that there is no engine oil leakage and exhaust gas
install oil pump strainer (1).
Tighten strainer bolt (3) first and then bracket bolt (4) to
specified torque.
start tightening at the center :
move wrench outward, tightening one bolt at a time. Tighten
bolts and nuts to specified torque.
Tighten drain plug to specified torque.
mounting and Mounting" in Section 7D.
Tighten transaxle stiffener bolts (c) first and next (d) with
specified torque.
(1).
Tighten bolts to specified torque.
Filter Replacement" in Section 0B.
leakage at each connection.
Advertisement
Table of Contents
