Table of Contents
Advertisement
7A1-12 MANUAL TRANSAXLE
1
1
OFF
ON
Back Up Lamp Switch Removal and Installa-
tion
Removal
1) Disconnect negative cable at battery.
2) Disconnect back up lamp switch coupler (1).
3
2. Clutch cable
3. Gear shift and select shaft assembly
2
3) Remove back up lamp switch (1).
1
Installation
1) Apply grease to new O-ring (1) and tighten back up lamp
switch (2) to specified torque.
2
Tightening torque
Back up lamp switch (a) : 23 N·m (2.3 kg-m, 17.0 lb-ft)
2) Connect negative cable at battery.
3) Connect back up lamp switch coupler (1).
Back Up Lamp Switch Inspection
Check backup lamp switch for function using ohmmeter.
Switch ON : Continuity
Switch OFF : No continuity
Advertisement
Table of Contents
