Table of Contents
Advertisement
5) Remove back door licence garnish (1).
6) Remove back door lock cylinder (2).
2
1
INSTALLATION
Reverse removal procedure to install back door lock assembly
noting the following instruction.
• Adjust door latch striker so that its center aligns with the cen-
ter of groove in door latch base.
Rearend Door Lock Assembly Inspection
• Check that door opens and closes smoothly and properly.
• Check that door stops in the secondary latched position
properly (preventing door from opening freely) and that door
closes completely in the fully latched position.
• Adjust door latch striker position if necessary.
Key Coding
Key Usage and Identification
Key is used for ignition and door lock cylinder. Keys are cut on
both edges to make them reversible.
Key identification is obtained from five character key code
stamped on key code tag. Using this key code, key code cutting
combination can be determined from a code list (available to own-
ers of key cutting equipment from suppliers).
If key codes are not available from records or tags, key code can
be obtained from the right hand door lock cylinder (if lock has not
been replaced). Lock cylinders supplied by the factory as service
parts are unmarked.
If original key is available, key code cutting combination can be
determined by laying key.
BODY SERVICE 9-53
Advertisement
Table of Contents
