Table of Contents
Advertisement
WARNING:
• Service on or around the air bag system components or wiring must be performed only by an
authorized SUZUKI dealer. Please observe all WARNINGS and "Service Precautions" under "On-
Vehicle Service" in this section before performing service on or around the air bag system compo-
nents or wiring. Failure to follow WARNINGS could result in unintended activation of the system or
could render the system inoperative. Either of these two conditions may result in severe injury.
• The procedures in this section must be followed in the order listed to disable the air bag system
temporarily and prevent false diagnostic trouble codes from setting. Failure to follow procedures
could result in possible activation of the air bag system, personal injury or otherwise unneeded air
bag system repairs.
CAUTION:
When fasteners are removed, always reinstall them at the same location from which they were
removed. If a fastener needs to be replaced, use the correct part number fastener for that application.
If the correct part number fastener is not available, a fastener of equal size and strength (or stronger)
may be used. Fasteners that are not reused, and those requiring thread-locking compound, will be
called out. The correct torque value must be used when installing fasteners that require it. If the above
conditions are not followed, parts or system damage could result.
General Description ......................................10B-4
Air Bag System Input/Output Table.............10B-4
System Components and Wiring
Location View..............................................10B-5
System Wiring Diagram ..............................10B-6
Diagnosis .......................................................10B-7
Diagnostic Trouble Code (DTC) ..................10B-7
Use of Special Tool .....................................10B-8
Intermittents and Poor Connections ..........10B-10
Air Bag Diagnostic System Check ............10B-11
Air Bag Diagnostic System Check Flow
Table .........................................................10B-12
DTC Check................................................10B-13
DTC Clearance .........................................10B-13
DTC Table.................................................10B-14
Scan Tool Data .........................................10B-15
Scan Tool Data Definition .........................10B-15
Table A – "AIR BAG" Warning Lamp
Comes ON Steady
Table B – "AIR BAG" Warning Lamp
Does Not Come ON
Table C – "AIR BAG" Warning Lamp
Flashes......................................................10B-16
SECTION 10B
AIR BAG SYSTEM
CONTENTS
Table D – SDM Cannot Communicate
Through the Serial Data Circuit................. 10B-20
DTC B1015 – Passenger Air Bag
Initiator Circuit Resistance High
DTC B1016 – Passenger Air Bag
Initiator Circuit Resistance Low
DTC B1018 – Passenger Air Bag
Initiator Circuit Short to Ground
DTC B1019 – Passenger Air Bag
Initiator Circuit Short to Power Circuit ....... 10B-22
DTC B1021 – Driver Air Bag Initiator
Circuit Resistance High
DTC B1022 – Driver Air Bag Initiator
Circuit Resistance Low
DTC B1024 – Driver Air Bag Initiator
Circuit Short to Ground
DTC B1025 – Driver Air Bag Initiator
Circuit Short to Power Circuit.................... 10B-27
DTC B1031 – Power Source Voltage
High
DTC B1032 – Power Source Voltage
Low ........................................................... 10B-33
AIR BAG SYSTEM 10B-1
10B
Advertisement
Table of Contents
