Table of Contents
Advertisement
Rearend Glass Removal and Installation
1. Rearend door glass
2. Fastener
"A"
"A"
2
1
"A"
"d"
"c"
2
"a"
3
1
"b"
3. Mounting hole
Refer to "Windshield Removal and Installation" in this section as
removal and installation procedures are basically the same. How-
ever, note the following.
1
2
"A"
5
2
5
1
4
• Observe the following precautions when applying adhesive
(1) along glass (2) edge.
• Adhesive (1) should be applied evenly especially in height.
• Be careful not to damage primer (3).
• With the position of fastener (5) properly aligned, install
glass (2) on rear door panel (4).
• Press glass against body quickly after adhesive (1) is
applied.
Adhesive amount specifications and position for rearend
door glass
Height "a": 13 mm (0.51 in.)
Width "b": 6 mm (0.24 in.)
Width "c": 14 mm (0.55 in.)
Position "d": 14.5 mm (0.57 in.) for glass upper section
Position "d": 16 mm (0.63 in.) for glass bottom section
Position "d": 32 mm (1.26 in.) for glass side sections
BODY SERVICE 9-21
Advertisement
Table of Contents
