Suzuki Ignis Service Manual page 3895

10-4 RESTRAINT SYSTEM
Service Precautions
Service and diagnosis
WARNING:
If replacing seat belt is necessary, replace buckle and ELR (or webbing) together as a set. This is for
the reason of ensuring locking of tongue plate with buckle.
If these parts are replaced individually, such a locking condition may become unreliable. For this rea-
son, SUZUKI will supply only the spare buckle and ELR (or webbing) in a set part.
Before servicing or replacing seat belts, refer to the following precautionary items.
• Seat belts should be normal relative to strap retractor and buckle portions.
• Keep sharp edges and damaging objects away from belts.
• Avoid bending or damaging any portion of belt buckle or latch plate.
• Do not bleach or dye belt webbing. (Use only mild soap and lukewarm water to clean it.)
• When installing a seat belt anchor bolt, it should be tightened by hand at first to prevent cross-threading and
then to specified torque.
• Do not attempt any repairs on retractor mechanisms or retractor covers. Replace defective assemblies with
new replacement parts.
• Keep belts dry and clean at all times.
• If there exist any parts in question, replace such parts.
• Replace belts whose webbing is cut or otherwise damaged.
• Do not put anything into trim panel opening which seat belt webbing passes through.
For Seat Belt with Pretensioner
Refer to "Service and diagnosis" under "Service Precautions" in Section 10B.
WARNING:
When performing service on or around air bag system components or air bag system wiring, disable
the air bag system. Refer to "Disabling air bag system" in Section 10B.
Failure to follow procedures could result in possible air bag activation, personal injury or unneeded
air bag system repairs.
Disabling air bag system
Refer to "Disabling air bag system" in Section 10B.
Enabling air bag system
Refer to "Enabling air bag system" in Section 10B.
Handling and storage
Refer to "Handling and storage" in Section 10B.
Disposal
Refer to "Disposal" under "Air Bag (Inflator) Module and Seat Belt Pretensioner Disposal" in Section 10B.
On-Vehicle Service