Suzuki Ignis Service Manual page 3977

10B-76 AIR BAG SYSTEM
Passenger Air Bag (Inflator) Module Removal and Installation
WARNING:
• Never attempt to disassemble or repair the passenger air bag (inflator) module. If any abnormality is
found, be sure to replace it with new one as an assembly.
• Be sure to read "Service Precautions" before starting to work and observe every precaution during
work. Neglecting them may result in personal injury or undeployment of the air bag when neces-
sary.
1
2
1
2
3, (a)
Removal
1) Disconnect negative cable at battery.
2) Disable air bag system. Refer to "Disabling air bag system"
in this section.
3) Remove passenger air bag (inflator) module (1) attaching
bolts (2) then remove passenger air bag (inflator) module (1)
from instrument panel member.
Installation
1) Install passenger air bag (inflator) module (1) to instrument
panel (2).
2) Tighten passenger air bag (inflator) module attaching bolts
(3) to specified torque.
Tightening torque
Passenger air bag (inflator) module mounting bolt
(a): 23 N·m (2.3 kg-m, 16.5 lb-ft)
3) Connect negative cable to battery.
4) Enable air bag system. Refer to "Enabling air bag system" in
this section.