Suzuki Ignis Service Manual page 3958

[A]
(C)
STEERING WHEEL
[A]: Fig. for STEP 1 and 2
[B]: Fig. for STEP 2
[C]: For DTC B1081
[D]: For DTC B1085
Special tool
(A): 09932-76010
(B): 09932-75010
(C): 09932-78310
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear diagnostic trouble code (Refer to "Diagnostic Trouble Code (DTC) Clearance"), if any.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
DTC B1082 or B1086
Step
1 1) With ignition switch OFF, disconnect side
air bag (inflator) module connector under
front seat cushion.
2) Check proper connection to applicable side
air bag (inflator) module at terminals in
"L25" or "L26" connector.
3) If OK, then connect Special tool (B) and (C)
to side air bag (inflator) module connector
disconnected at the step 1.
With ignition switch ON, is DTC B1082 or
B1086 still current?
[B]
[C]
(A)
"L21-18" "L21-19"
"L25", "L26"
(B)
Action
[D]
(A)
(A)
Yes
Go to step 2.
AIR BAG SYSTEM 10B-57
(A)
"L21-20" "L21-21"
(A)
No
Ignition switch OFF.
Replace side air bag
(inflator) module (Refer to
"Side Air Bag (Inflator)
Module (If Equipped)
Inspection" in this sec-
tion.).