Table of Contents
Advertisement
3
1
5
1
1
2
1
3
12) Disconnect door opening control rod (1) from outside handle.
13) Disconnect door latch control rod (2).
7
14) Disconnect door lock motor lead wire at coupler (if
equipped).
8
15) Remove door lock knob (3).
2
16) Loosen door latch screw (4), door latch actuator bolt (5) (if
equipped with power door lock) and remove door lock
assembly (6).
4
6
17) Remove key cylinder retainers (1).
18) Remove key cylinder (2).
2
INSTALLATION
Reverse removal procedure to install front door lock assembly
noting the following instructions.
• Install key cylinder as fallows:
a) Install key cylinder (1) to front door panel.
b) Insert key cylinder upper retainer (2).
c) Insert key cylinder lower retainer (3).
d) Insert the retainers all the way until lower retainer tab
engages with upper retainer cutout.
• Apply grease to sliding parts of door latch assembly.
Grease 99000-25010
• Move door latch striker (2) up or down so its center aligns
with the center of groove "A" on the door lock assembly (1)
as shown.
Striker should be moved vertically and placed level. Do not
adjust door lock.
3. Shaft
BODY SERVICE 9-47
Advertisement
Table of Contents
