Suzuki Ignis Service Manual page 3676

1
1
Transfer Disassembly and Assembly
Disassembly
1) Remove retainer bolts (2) and remove transfer output
retainer (1).
2) Remove transfer case bolts (1).
3) Separate right case with intermediate shaft from left case by
tapping with plastic hammer.
1
4) If reduction drive gear oil seal replacement is necessary,
remove oil seal from left case using special tool.
Special tool
(A) : 09913-50121
5) If bevel gear shim adjustment is necessary, remove driven
gear bearing outer races as follows.
NOTE:
If either or both the following part(s) is/are replaced,
bevel gear shim adjustment is necessary in assembly.
• Driven gear bearing
• Bevel gear nut
• Bevel gear
• Reduction driven gear
TRANSFER 7D-9