Table of Contents
Advertisement
7A1-10 MANUAL TRANSAXLE
"a"
2
Gear Shift Control Lever and Cable Adjust-
ment
• Adjustment of shift cable:
a) With shift control lever in "NEUTRAL" position, adjust shift
1
Distance "a" : 215 mm (8.46 in.)
2
b) After shift cable adjustment, tighten cable lock nut (4) to
Tightening torque
Cable lock nut (a) : 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
c) Make sure that boots are installed correctly.
1
• Adjustment of select cable:
a) With shift control lever in "NEUTRAL" position, adjust select
b) After select cable adjustment, tighten cable lock nut (4) to
Tightening torque
Cable lock nut (a) : 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
cable adjusting nut (3) so that distance "a" between edge of
instrument panel (1) and center of shift knob (2) measured
as specified value.
specified torque.
cable adjusting nut (3) so that the tip of select arm (cable
joint point) (1) and the center rip of gear shift control lever
assembly (2) are aligned as shown.
specified torque.
Advertisement
Table of Contents
