Table of Contents
Advertisement
8D-40 WINDOWS, MIRRORS, SECURITY AND LOCKS
T1
1
T1
2
1
1
4
3
6) Check if the ammeter shows the ON/OFF switching opera-
E
[A]: Current on ammeter
[B]: Heater/bimetal temperature
T2
E
Recommended measurement condition
Room temperature: 20°C (68°F)
T2
Information Display Removal and Installation
REMOVAL
1) Disconnect negative (–) cable at battery.
2) Remove audio unit (1) from center upper garnish (2) as
3) Remove center upper garnish (1) from instrument panel (2)
6
4) Remove display unit (6) from instrument panel (2) by remov-
5) Disconnect connector from display unit.
5
2
INSTALLATION
Reverse removal procedure to install display unit.
tion of bimetal as shown in the figure.
If check result is not as specified, replace seat cushion as
assembly.
C: Current
D: Temperature
E: Bimetal ON/OFF operation
T: Time
T1: Heating time at laboratory (Approx. 10 minutes)
(Will vary depending on ambient/seat temperature)
T2: Approx. 15 seconds
1. Approx. 42°C (108°F) at bimetal
(Will be lower on seat surface)
shown.
by removing screw (3), audio unit connector (4) and antenna
wiring (5).
ing 2 screws.
Advertisement
Table of Contents
