Suzuki Ignis Service Manual page 3791

8D-36 WINDOWS, MIRRORS, SECURITY AND LOCKS
4
2
3
M1
M2 COM
Power Door Mirror Actuator Removal and
Installation
REMOVAL
1) Remove door garnish (1) and front door trim (2) from door.
2) Disconnect door mirror coupler.
3) Remove door mounting bolts (3), and remove door mirror
assembly (4).
1
INSTALLATION
Reverse removal procedure to install door mirror assembly noting
the following construction.
• Be careful not to pinch harness between door and door mir-
ror.
• Connect door mirror connector securely.
Power Door Mirror Actuator Inspection
CAUTION:
Never short positive and negative probes to prevent wire
harness from damage.
Check that door mirror operates properly when battery voltage is
applied to connector terminals as follows.
• Connect battery positive and negative terminal to the door
mirror terminal shown below.
If it does not follow the table's operation, replace door mirror
assembly.
Power door mirror actuator specification
Terminal
COM
Operation
Up
Down
Left
Right
M1 M2