Suzuki Ignis Service Manual page 3683

7D-16 TRANSFER
Assembly
1) Press-fit intermediate right bearing to intermediate shaft.
2) Install intermediate center oil seals (1) to case using special
tool, and apply grease to oil seal lip.
CAUTION:
Use care the installation direction and depth of oil seals
for correct installation.
Special tool
(A) : 09924-84510-005
(B) : 09913-75821
"A" : Grease 99000-25010
Transfer intermediate center oil seals installing depth
"a" : 16.0 – 16.5 mm (0.630 – 0.650 in.)
"b" : 4.0 – 4.5 mm (0.157 – 0.177 in.)
3) Install intermediate shaft (1) to right case (2), and install
snap ring (3).
Special tool
(A) : 09952-76011
4) Install reduction drive gear oil seal (1) to right case (2).
Special tool
(A) : 09913-75810
Transfer right case oil seal installing depth
"a" : 1.0 – 1.5 mm (0.039 – 0.059 in.)
5) Fill grease to inside of oil seal about 3 g (0.11 oz), and apply
grease to oil seal lip.
"A" : Grease 99000-25010
Transfer Output Retainer Disassembly and
Assembly
Disassembly
1) Uncaulk flange nut.