Suzuki Ignis Service Manual page 3971

10B-70 AIR BAG SYSTEM
4 3 1
2
• Steering wheel and driver air bag (inflator) module
– Check for damage or air bag (inflator) module fitness.
– Check trim cover (pad surface) for cracks.
– Check wire harness and connector for damage or tight-
ness.
If any faulty condition is found in above checks, replace faulty
part.
• Contact coil and combination switch assembly
– Check wire harness and connectors for damage or tight-
ness.
– Check contact coil case for damage.
If any faulty condition is found in above checks, replace.
• SDM
– Check for external damage such as deformation, scratch,
crack, peeled paint, etc.
– Check that SDM cannot be installed properly due to a
cause in itself.
– Check that connector or lead wire of SDM has a scorching,
melting or damage.
– Check SDM connector and terminals for tightness.
– Check SDM sets a diagnostic trouble code (Refer to "Diag-
nostic Trouble Code (DTC) Check".) and the diagnostic
table leads to a malfunctioning SDM.
If any faulty condition is found in above checks, replace.
• Side sensors
– Check sensor (1) and under body (2) for dents, cracks,
deformation or rust.
– Check sensor connector (sensor side and harness side) (3)
or sensor lead wire (4) for damage, crack, scorching or
melting.
If any faulty condition is found in above checks, replace.
• Instrument panel member and reinforcement
– Check for any distortion, bending, cracking or other dam-
age.
If any faulty condition is found in above checks, replace.