Table of Contents
Advertisement
8D-20 WINDOWS, MIRRORS, SECURITY AND LOCKS
3
1
C
2
Washer Tank and Washer Pump Removal and
Installation
REMOVAL
2
INSTALLATION
Reverse removal procedure for installation.
Washer Pump Inspection
1
2
Front Wiper Motor Inspection
A
B
D
1
If check result is not as specified, replace wiper motor.
1) Disconnect negative cable at battery.
2) Remove front fender lining (RH).
3) Remove washer tank attaching nuts and inlet pipe (3).
4) Disconnect pump lead wire coupler and hose(s).
5) Remove washer tank (1).
6) Remove washer pump (2) from washer tank (1).
1) Connect battery (+) terminal to pump terminal "a", and bat-
tery (–) terminal to pump terminal "b".
Check that water jets from front washer side (1).
2) Connect battery (+) terminal to pump terminal "b", and bat-
tery (–) terminal to pump terminal "a".
Check that water jets from rear washer side (2).
1) For low speed check.
a) Use a 12 V battery
b) Connect battery positive (+) terminal to wiper motor termi-
nal "A" and battery negative (–) terminal to wiper motor
bracket (1) (wiper motor ground).
If motor (2) rotates at low revolution speed of 44 to 52 rpm,
it is proper.
2) For high speed check.
a) Use a 12 V battery.
b) Connect battery positive (+) terminal to wiper motor termi-
nal "B" and battery negative (–) terminal to wiper motor
bracket (1) (wiper motor ground).
If motor (2) rotates at high revolution speed of 64 to 78 rpm,
it is proper.
Advertisement
Table of Contents
