Suzuki Ignis Service Manual page 3751

8C-10 INSTRUMENTATION/DRIVER INFORMATION
Fuel Level Sensor (Gauge Unit) Inspection
• Check that resistance between terminals "2" and "3" of fuel
level sensor changes with change of float position.
• Check resistance between terminals "2" and "3" in each float
position.
If the measured value is out of specification, replace fuel
level sensor.
Fuel level sensor specification
Float Position
Full Upper "a"
Middle (1/2) "b"
Full Lower "c"
1. Fuel pump assembly
VSS Removal and Installation
Refer to "Vehicle speed sensor (VSS) removal and installation" in
Section 6E1.
VSS Inspection
Refer to "Vehicle speed sensor (VSS) inspection" in Section 6E1.
56 mm (2.20 in.)
119.2 mm (4.69 in.)
200.5 mm (7.89 in.)
Resistance (Ω)
38 – 42
157 – 163
276 – 284