Table of Contents
Advertisement
3) Aligning clutch disc to flywheel center using special tool,
install clutch cover (1) and bolts. Then tighten bolts to speci-
fication.
NOTE:
• While tightening clutch cover bolts, compress clutch
disc with special tool (C) by hand so that disc cen-
tered.
• Tighten cover bolts little by little evenly in diagonal
order.
Special tool
(A) : 09924-17810
(C) : 09923-36320
Tightening torque
Clutch cover bolts (b) : 23 N·m (2.3 kg-m, 16.5 lb-ft)
4) Slightly apply grease to input shaft (1), then join transaxle
assembly with engine referring to "Transaxle Unit Dismount-
ing and Remounting" in Section 7A1.
"A" : Grease, 99000-25210
NOTE:
When inserting transaxle input shaft to clutch disc, turn
crankshaft little by little to match splines.
Clutch Cover, Clutch Disc and Flywheel
Inspection.
Input shaft bearing
Check bearing (1) for smooth rotation and replace it if abnormality
is found.
CLUTCH 7C1-11
Advertisement
Table of Contents
