Table of Contents
Advertisement
Step
3
1) With ignition switch OFF, disconnect "G75"
connector in instrument panel harness.
2) Check proper connection at "G75-3" ("RED"
wire) terminal.
3) If OK, then ignition switch ON, and then
check voltage from "G75-3" ("RED" wire)
terminal to body ground.
Is voltage 8 V or more?
4
1) With ignition switch OFF, reconnect SDM
connector "L21".
With ignition switch ON, is DTC B1032 current?
[A]
[A]: Fig. for STEP 2
[B]: Fig. for STEP 3
1. Instrument panel harness side connector
Special tool
(A): 09932-76010
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear diagnostic trouble codes (Refer to "Diagnostic Trouble Code (DTC) Clearance"), if any.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
Action
"L21-32"
(A)
Yes
Check for proper connec-
tion at "L63-3" terminal.
If OK, repair high resis-
tance or open in "RED"
wire (between "L63" con-
nector and SDM).
Substitute a known-good
SDM and recheck.
[B]
1
"G75-1"
AIR BAG SYSTEM 10B-35
No
Possibly faulty points are
as follows. Check each of
them and repair as neces-
sary.
• Circuit from battery to
"G75" connector
• Charging System
(Refer to "Under-
charged battery" in
Section 6H.)
Intermittent trouble check
for intermittent referring to
"Intermittents and Poor
Connections" in this sec-
tion.
(A)
Advertisement
Table of Contents
