Table of Contents
Advertisement
8C-12 INSTRUMENTATION/DRIVER INFORMATION
Ignition Key Remainder and Light Remainder
Warning Buzzer Inspection
The ignition key and light remainder warning buzzer is integrated
in combination meter.
Therefore, check the buzzer circuit referring to "Combination
Meter Circuit" in this section.
If no failure is found, repair wiring harness. If a failure is found in
the buzzer circuit, replace combination meter.
Engine Oil Pressure Switch Inspection
1) Disconnect engine oil pressure switch (1) lead wire.
2) Check for continuity between engine oil pressure switch ter-
minal (2) and cylinder block (3) as shown in the figure.
If not as specified, replace engine oil pressure switch (1).
Engine oil pressure switch specification
During engine running: No continuity
At engine stop: Continuity
4. Engine oil filter
F. Front
Engine Oil Pressure Switch Removal and
Installation
Refer to "Oil Pressure Check" in Section 6A1.
Advertisement
Table of Contents
