Table of Contents
Advertisement
9-18 BODY SERVICE
"c"
"a"
2
"b"
"d"
"a"
2
1
"b"
3
3
2
1
2
2
3
2
"c"
"a"
2
"b"
1
8) Using new brush, apply sufficient amount of primer for glass
along glass surface to be adhered to body.
NOTE:
• Be sure to refer to maker's instruction for proper han-
dling and drying time.
• Do not apply primer on outside of ceramic coated sur-
face.
• Do not touch primer coated surface.
Width applied primer for windshield
"a": 22 mm (0.87 in.)
"b": 15 mm (0.59 in.)
1. Molding
2. Spacer
3. Apply primer
9) Apply primer for molding along molding surface all around.
10) Apply adhesive (1) referring to figure.
NOTE:
• Press glass (2) against fittings surface of body panel
quickly after adhesive (1) is applied.
• Use of rubber sucker grip is helpful to hold and carry
glass after adhesive (1) is applied.
• Perform steps 8) to 9) within 10 min. to ensure suffi-
cient adhesion.
• Be sure to refer to adhesive maker's instruction for
proper handling and drying time.
• Start from bottom side of glass (2).
• Be careful not to damage primer.
Adhesive amount specifications and position for wind-
shield
Width "a": Approx. 7 mm (0.27 in.)
Height "b": Approx. 15 mm (0.59 in.)
Position "c": Approx. 10 mm (0.39 in.) for front, rear and
upper sections
Position "d": Approx. 17 mm (0.67 in.) for bottom section.
3. Molding
Advertisement
Table of Contents
