Table of Contents
Advertisement
NOTE:
Before taking measurement, check for rotation by hand
more than 15 revolutions.
6) Tighten bevel pinion nut (special tool) (1) so that specified
bearing preload is obtained.
Drive bevel pinion bearing preload (at 50 rpm)
0.5 – 1.3 N·m (5.0 – 13.0 kg-cm, 0.35 – 0.90 lb-ft)
NOTE:
• When setting dial gauge to bearing form dummy with
dummy shaft, tighten screw lightly. Be careful not to
overtighten it, which will cause damage to dial gauge.
• With dial gauge set, turn dummy back and forth by
hand a couple of times and attain accurate 0 (zero)
adjustment.
• It is desirable that short pointer indicates beyond 2 mm
when long one is at 0 (zero).
7) Set dial gauge to bearing form dummy with dummy shaft and
make 0 (zero) adjustment on surface plate.
8) Put block dummy (3) on pinion form dummy (2).
Special tool
(A): 09922-76510
NOTE:
• Repeat turning back and forth of dummy and measure
distance as far as top surface of block dummy accu-
rately.
• When dial gauge measuring tip extends from 0 (zero)
position, pointer turns counterclockwise.
• Measured value may exceed 1 mm. Therefore, it is also
necessary to know reading of short pointer.
9) Place zero-adjusted bearing form dummy with dummy shaft
(1) and dial gauge set on block dummy (3) and take mea-
surement between zero position and extended dial gauge
measuring tip.
10) Obtain adjusting shim thickness by using measured value by
dial gauge in the following equation.
Necessary shim thickness = Dial gauge measured value D
REAR DIFFERENTIAL 7F-15
Advertisement
Table of Contents
