Table of Contents
Advertisement
10B-50 AIR BAG SYSTEM
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear diagnostic trouble code (Refer to "Diagnostic Trouble Code (DTC) Clearance"), if any.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
DTC B1071 – Internal SDM Fault
DTC WILL BE SET WHEN
An internal SDM fault is detected by SDM.
NOTE:
Before executing items below, be sure to perform "Air Bag Diagnostic System Check".
NOTE:
DTC B1071 can never be cleared once it has been set.
1) Ignition switch OFF.
2) Replace SDM.
3) Repeat "Air Bag Diagnostic System Check".
DTC B1072 – Internal Side Sensor (Driver Side) Fault
DTC B1074 – Internal Side Sensor (Passenger Side) Fault
DTC WILL BE SET WHEN
DTC B1072 or B1074:
SDM receive internal fault signal from side sensor.
NOTE:
Before executing items below, be sure to perform "Air Bag Diagnostic System Check".
1) Ignition switch OFF.
2) Replace side sensor.
3) Repeat "Air Bag Diagnostic System Check".
Advertisement
Table of Contents
