Suzuki Ignis Service Manual page 3901

10-10 RESTRAINT SYSTEM
Rear Seat Belt Removal and Installation
REMOVAL
WARNING:
Be sure to read "Service Precautions" in Section 10B before starting to work and observe every pre-
caution during work.
1) Remove rear seat cushion, if necessary.
2) Remove rear seat belt(s) as referring to "Rear Seat Belt Components" in this section.
INSTALLATION
Reverse removal procedure to install rear seat belt(s) noting the following constructions.
• Seat belt anchor bolts should have an unified fine thread (7/16-20 UNF). Under no circumstances should
any different sized or metric screw threads be used.
• Be sure to tighten rear seat belt mounting bolts in order ("a" – "c") referring to "Rear Seat Belt Components"
in this section.
• Tighten rear seat belt mounting bolts to specified torque referring to "Rear Seat Belt Components" in this
section.
Rear Seat Belt Inspection
• Check the rear seat belt in the same way as "Front Seat Belt Inspection" in this section.
• As to seat belts with A-ELR, check them as follows in addition to above check.
– With vehicle at stop, pull seat belt all the way out, let it retract a little and try to pull it. It should not be
pulled out, that is, it should be locked where retracted.
– Let seat belt retract to its original state. Next, pull it half way out, let it retract a little and try to pull it again.
It should be pulled out smoothly, that is it should not be locked at this time.
Upper and lower anchor bolt
Retractor assembly bolt
Retractor assembly screw
Buckle bolt
Tightening Torque Specification
Fastening part
Tightening torque
N•m kg-m
50 5.0
50 5.0
5.5 0.55
50 5.0
lb-ft
36.0
36.0
4.0
36.0