Suzuki Ignis Service Manual page 3771

8D-16 WINDOWS, MIRRORS, SECURITY AND LOCKS
1
G46-6
G46-8
G46-2
G46-4
Front washer linked circuit
1) Check that wiper motor operates with the wiper switch at low
position, and return to original position with the wiper switch
turned OFF.
2) Disconnect negative cable at battery.
3) Disable air bag system. Refer to "Disabling air bag system"
in Section 10B.
4) Pull out front wiper intermittent timer (1).
5) Disconnect coupler, and connect negative cable at battery.
6) Check that the voltage and resistance between the following
terminals are as specification.
Terminals
When ignition switch is in OFF.
G46-2 and
ground When ignition switch is in ON.
G46-6 and
When ignition switch is in OFF.
ground
G46-8 and
When ignition switch is in OFF.
ground
When ignition switch is in ON
and front washer switch is in
G46-4 and OFF.
ground
When ignition switch is in ON
and front washer switch is in
ON.
If check result is not satisfactory, repair wiring and check wiper
motor.
NOTE:
When front washer switch is in ON position for one sec-
ond or more and then turned OFF, the wiper motor oper-
ates at low speed for approximately 5 seconds after front
washer switch is turned OFF.
7) After intermittent timer lead wire coupler is connected and
intermittent timer is installed, enable air bag system. Refer to
"Enabling air bag system" in Section 10B.
Condition Specification
0 V
10 – 15 V
Continuity
Continuity
0 V
10 – 15 V