Table of Contents
Advertisement
6E1-26 ENGINE AND EMISSION CONTROL SYSTEM
[A]
1
[B]
2
1) Install injector to special tool (injector checking tool).
Special tool
(A): 09912-58421
(B): 09912-57610
2) Connect special tools (hose and attachment) to fuel feed
pipe (1) of vehicle.
3) Connect special tool (test lead) to injector.
Special tool
(C): 09930-88530
4) Install suitable vinyl tube onto injector nozzle to prevent fuel
from splashing out when injecting.
5) Put graduated cylinder under injector.
6) Operate fuel pump and apply fuel pressure to injector as fol-
lows:
a) When using scan tool:
i) Connect scan tool (1) to DLC with ignition switch OFF.
ii) Turn ignition switch ON, clear DTC and select "MISC
TEST" mode on scan tool.
iii) Turn fuel pump ON by using scan tool.
b) Without using scan tool:
i) Remove fuel pump relay from connector.
ii) Connect two terminals of relay connector using service
wire (2) as shown in figure.
CAUTION:
Check to make sure that connection is made between
correct terminals. Wrong connection can cause damage
to ECM, wire harness, etc.
iii) Turn ignition switch ON.
[A]: When using Suzuki Scan Tool
[B]: When not using Suzuki Scan Tool
Advertisement
Table of Contents
