Table of Contents
Advertisement
10B-72 AIR BAG SYSTEM
1
3
2
3
2
SDM Removal and Installation
WARNING:
During service procedures, be very careful when han-
dling a Sensing and Diagnostic Module (SDM).
Be sure to read "Service Precautions" before starting to
work and observe every precaution during work. Neglect-
ing them may result in personal injury or inactivation of
the air bag system when necessary.
Removal
1) Disconnect negative cable at battery.
2) Disable air bag system. Refer to "Disabling air bag system"
in this section.
3) Remove front and rear center console boxes (1) by removing
screws and clips.
4) Remove front center console box mounting bracket (2).
5) Disconnect SDM connector (2) from SDM (3).
6) Remove SDM (3) from vehicle.
Advertisement
Table of Contents
