Table of Contents
Advertisement
1
8
7
6
5
18
17
16
15
14
13
12
V
Keyless entry system circuit check
Terminal
Wire
G11-7
GRN/YEL
G11-8
GRN/RED
G11-15
BRN/RED
Keyless Entry System Circuit Inspection
Check that the voltage and continuity between the following termi-
nals and body ground are specifications under each conditions.
If check result is not as specified, check relevant circuit.
4
3
2
1
If circuit is normal, recheck keyless entry system circuit as fol-
11
10
9
lows.
Circuit
Hazard waning signal cir-
cuit (right side)
Hazard waning signal cir-
cuit (left side)
Door switch & interior light
circuit
WINDOWS, MIRRORS, SECURITY AND LOCKS 8D-33
NOTE:
If keyless entry system is in interior light signal mode,
change to hazard warning light signal mode referring to
"Change of Signal Mode" in this section.
1) Substitute a known-good door lock controller.
2) Register key code referring to "Transmitter Code Registra-
tion Procedure" in this section.
3) Recheck keyless entry system operation inspection.
1. Door lock controller
Specification
Figure "A"
Figure "B"
Figure "C"
Figure "A"
Figure "B"
Figure "C"
Figure "D"
Condition
Push "LOCK" button on transmitter
once.
Push "UNLOCK" button on transmitter
once.
Push "LOCK" button on transmitter
twice within 2 seconds.
Push "LOCK" button on transmitter
once.
Push "UNLOCK" button on transmitter
once.
Push "LOCK" button on transmitter
twice within 2 seconds.
Fulfill the following conditions.
• All door is close.
• Interior light switch is in middle posi-
tion.
• 20 seconds after pushing "UNLOCK"
button on transmitter once.
Advertisement
Table of Contents
