Table of Contents
Advertisement
6E1-32 ENGINE AND EMISSION CONTROL SYSTEM
Camshaft position sensor (CMP sensor) removal
and installation
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect connector from camshaft position sensor.
3) Remove camshaft position sensor from cylinder head.
INSTALLATION
1) Check that O-ring is free from damage.
2) Check that camshaft position sensor and signal rotor teeth
are free from any metal particles and damage.
3) Install camshaft position sensor to cylinder head.
Tightening torque
(a)
Camshaft position sensor bolt
(a): 10 N·m (1.0 kg-m, 7.5 lb-ft)
4) Connect connector to it securely.
5) Connect negative cable to battery.
Crankshaft position sensor (CKP sensor) inspection
Check crankshaft position sensor referring to Steps 2 and 7 of
"DTC P0335 Crankshaft Position (CKP) Sensor Circuit" in Section
6. If malfunction is found, replace.
Crankshaft position sensor (CKP sensor) removal
and installation
REMOVAL
1) Disconnect negative cable at battery.
2) Remove generator drive belt, loosen pivot bolt (2) and move
generator rearward.
3) Disconnect connector from crankshaft position sensor.
4) Remove crankshaft position sensor (1) from cylinder block.
Advertisement
Table of Contents
