Suzuki Ignis Service Manual page 3773

8D-18 WINDOWS, MIRRORS, SECURITY AND LOCKS
1
G47-6
G47-9
G47-8 G47-2
Rear wiper intermittent circuit
1) Check that wiper motor operates with the wiper switch at
rear position, and return to original position with the wiper
switch turned OFF.
2) Disconnect negative cable at battery.
3) Disable air bag system. Refer to "Disabling air bag system"
in Section 10B.
4) Pull out rear wiper intermittent timer (1).
5) Disconnect coupler, and connect negative cable at battery.
6) Check that the voltage and resistance between the following
terminals are as specifications.
Terminals
When ignition switch is in OFF.
G47-2 and
ground When ignition switch is in ON.
G47-6 and
When ignition switch is in OFF.
ground
G47-8 and
When ignition switch is in OFF.
ground
When ignition switch is in ON
and rear wiper switch is in OFF.
G47-9 and
When ignition switch is in ON
ground
and rear wiper switch is in ON
position.
If check result is not satisfactory, repair wiring and check wiper
motor.
NOTE:
The wiper motor operates the wiper arms at an interval of
approximately 6 seconds per one operation.
7) After intermittent timer lead wire coupler is connected and
intermittent timer is installed, enable air bag system. Refer to
"Enabling air bag system" in Section 10B.
Condition Specification
0 V
10 – 15 V
Continuity
Continuity
0 V
10 – 15 V