Table of Contents
Advertisement
10 cm
(3.9 in.)
2
4
3
iii) Tie webbing (1) tightly at 10 cm (3.9 in.) from cutting edge
as shown.
iv) Tie seat belt pretensioner (2) with wire harness (3) to
wheel-installed tire (4) as shown.
Wire harness specification:
Stripped wire harness section 1.25 mm
1
more (Stripped wire harness diameter 1.25 mm (0.05 in.)
or more)
NOTE:
Wind wire harness (3) around at least 3 times.
5
v) Clear space (5) on ground about 185 cm (6 ft) in diameter
where seat belt pretensioner (2) is to be activated. Paved,
outdoor location where there is no activity is preferred. If
outdoor location is not available, space on shop floor
where there is no activity and provide sufficient ventilation.
Ensure no loose or flammable objects are within activation
area.
vi) Place wheel-installed tire (4) with seat belt pretensioner
(2) on ground in step v).
AIR BAG SYSTEM 10B-83
2
2
(0.0019 in.
) or
Advertisement
Table of Contents
