Suzuki Ignis Service Manual page 3656

Clutch Cable Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Remove clutch cable joint nut (1).
3) Remove joint pin (2) from clutch release lever (3).
4) Disconnect cable hook (1) from clutch pedal (4).
5) Remove clutch cable (3) from bracket (5) by turning cable
cap (2) about 90° as shown.
Installation
1) Apply grease to cable end hook (1) and also joint pin (2)
before installing cable.
"A" : Grease 99000-25010
2) Hook cable end with pedal using screwdriver or long nose
pliers from cabin inside, then join inner cable wire joint pin in
release lever.
3) Install clutch cable (2) to bracket (3) by turning cable cap (1)
about 90° as shown.
4) Screw in joint nut and adjust clutch pedal free travel referring
to "Clutch pedal free travel" in this section.
NOTE:
Take care that cable grommet (4) has specific installing
direction as shown in the figure.
5) Check clutch for proper function with engine running.
CLUTCH 7C1-5