Table of Contents
Advertisement
10B-84 AIR BAG SYSTEM
(A)
[A]
10 m (33 ft)
1
(A)
[B]
1
[C]
10 m (33 ft)
(A)
1
5
(B)
[D]
(A)
10 m (33 ft)
1
(B)
10 m (33 ft)
(B)
2
3
4
5
7) Stretch deployment harness (A) from air bag (inflator) mod-
ule or seat belt pretensioner to its full length 10 m (33 ft).
Special tool
(A): 09932-75030
8) Place 12 volts vehicle battery (1) near shorted end of deploy-
ment harness (A).
9) Verify that area around air bag (inflator) module or seat belt
pretensioner is clear of all people and loose or flammable
objects.
10) Connect adapter cable (B) as follows.
Special tool
(B): 09932-78331
• For driver air bag (inflator) module:
Verify that driver air bag (inflator) module is resting with its
vinyl trim cover facing up, and connect adapter cable (B) to
driver air bag (inflator) module.
• For passenger air bag (inflator) module:
Verify that passenger air bag (inflator) module is firmly and
properly secured on deployment fixture (special tool), and
connect adapter cable (B) to passenger air bag (inflator)
module.
• For side air bag (inflator) module:
Verify that front seat back with side air bag (inflator) module
(2) resting with its frontal seat cover facing up, and connect
adapter cable (B) to side air bag (inflator) module.
• For seat belt pretensioner:
Connect adapter cable (B) to seat belt pretensioner.
11) Connect adapter cable (B) to deployment harness (A) con-
nector and lock connectors with lock slider.
12) For seat belt pretensioner
a) Pile 2 wheel-installed tires (3) on top of tire with seat belt
pretensioner (4), and tie them with wire harness (5) as
shown.
Wire harness specification:
Stripped wire harness section 1.25 mm
more (Stripped wire harness diameter 1.25 mm (0.05 in.)
or more)
NOTE:
Wind wire harness around at least 2 times.
b) Drape blanket (6) over those tires.
[A]: For driver air bag (inflator) module
[B]: For passenger air bag (inflator) module
[C]: For side air bag (inflator) module
[D]: For seat belt pretensioner
2
2
(0.0019 in.
) or
Advertisement
Table of Contents
