Table of Contents
Advertisement
A
3
C
2
1
A
B
D
C
1
B
A
3
D
C
1
3) Automatic stop action check.
a) Connect 12 V battery (+) terminal to wiper motor terminal
"A" and battery (–) terminal to bracket (1) (wiper motor
B
ground), and let the motor (2) turn.
D
b) Disconnect wiper motor terminal "A" from battery, and let
the motor (2) stop.
c) Connect wiper motor terminal "A" and "D" with a jumper
wire (3), and connect wiper motor terminal "C" to battery (+)
terminal. Observe the motor (2) turns once again then
stops at a given position.
d) Repeat a) thru c) several times and inspect if the motor (2)
stops at the given position every time.
If check result is not as specified, replace wiper motor.
Rear Wiper Motor Inspection
1) Testing motor action.
a) Use a 12 V battery.
b) Connect battery positive (+) terminal to wiper motor termi-
nal "A" and battery negative (–) terminal to wiper motor
2
bracket (1) (wiper motor ground).
If motor (2) rotates at low revolution speed of 35 to 45 rpm,
it is proper.
If check result is not as specified, replace rear wiper motor.
2) Automatic stop action check.
a) Connect 12 V battery (+) terminal to wiper motor terminal
"A" and battery (–) terminal to bracket (1) (wiper motor
ground), and let the motor (2) turn.
b) Disconnect wiper motor terminal "A" from battery, and let
2
the motor (2) stop.
c) Connect wiper motor terminal "A" and "D" with a jumper
wire (3), and connect wiper motor terminal "C" to battery (+)
terminal. Observe the motor (2) turns once again then
stops at a given position.
d) Repeat a) thru c) several times and inspect if the motor (2)
stops at the given position every time.
If check result is not as specified, replace rear wiper motor.
WINDOWS, MIRRORS, SECURITY AND LOCKS 8D-21
Advertisement
Table of Contents
