Suzuki Ignis Service Manual page 3770

1
G46-6
G46-9
G46-2
G46-8
WINDOWS, MIRRORS, SECURITY AND LOCKS 8D-15
Front wiper intermittent circuit
1) Check that wiper motor operates with the wiper switch at low
position, and return to original position with the wiper switch
turned OFF.
2) Disconnect negative cable at battery.
3) Disable air bag system. Refer to "Disabling air bag system"
in Section 10B.
4) Pull out front wiper intermittent timer (1).
5) Disconnect coupler, and connect negative cable at battery.
6) Check that the voltage and resistance between the following
terminals are as specifications.
Terminals
When ignition switch is in OFF.
G46-2 and
ground When ignition switch is in ON.
G46-6 and
When ignition switch is in OFF.
ground
G46-8 and
When ignition switch is in OFF.
ground
When ignition switch is in ON
and front wiper switch is in
OFF.
G46-9 and
ground
When ignition switch is in ON
and front wiper switch is in
intermittent position.
If check result is not satisfactory, repair wiring and check wiper
motor.
NOTE:
The wiper motor operates the wiper arms at an interval of
approximately 6 seconds per one operation at low speed.
7) After intermittent timer lead wire coupler is connected and
intermittent timer is installed, enable air bag system. Refer to
"Enabling air bag system" in Section 10B.
Condition Specification
0 V
10 – 15 V
Continuity
Continuity
0 V
10 – 15 V