Table of Contents
Advertisement
[A]
(B)
(A)
1
[B]
(B)
(A)
1
[C]
(B)
(A)
1
[D]
5) Check that there is no open, short or damage in special tools
(deployment harness (A) and adapter cable (B)). If any faulty
condition is found, do not use it and be sure to use new
deployment harness (A) and/or adapter cable (B). And con-
nect adapter cable (B) to deployment harness (A) and lock
connectors with lock slider.
NOTE:
If faulty of seat belt pretensioner connector of adapter
cable (B) is found, replace it to spare connector (special
tool).
Special tool
(A): 09932-75030
(B): 09932-78331
6) Short two deployment harness leads (1) together by fully
seating one banana plug into the other.
WARNING:
Deployment harness (A) shall remain shorted and not be
connected to 12 volts vehicle battery until you are ready
to deploy air bag (inflator) module or activate seat belt
pretensioner.
2
7) Connect adapter cable (B) in series with deployment har-
ness (A) to air bag (inflator) module or seat belt pretensioner
as follows.
• For air bag (inflator) module:
Connect adapter cable (B) in series with deployment har-
ness (A) and push adapter cable (B) connector to air bag
(inflator) module connector (driver, passenger or side of
driver and passenger) till click can be heard.
• For side air bag (inflator) module:
Connect adapter cable (B) deployment harness (A) and lock
(A)
connector with lock lever.
• For seat belt pretensioner:
Connect adapter cable (B) in series with deployment har-
1
ness (A) to seat belt pretensioner and lock connector with
lock part.
[A]: For driver air bag (inflator) module
(B)
[B]: For passenger air bag (inflator) module
[C]: For side air bag (inflator) module
[D]: For seat belt pretensioner
2. Seat back assembly
AIR BAG SYSTEM 10B-89
Advertisement
Table of Contents
