Table of Contents
Advertisement
7A1-28 MANUAL TRANSAXLE
Assembly
1) Clean mating surface of guide case.
2) Install fifth gear referring to "Fifth Gear Disassembly and
Assembly" in this section.
3) Install gear shift and select shaft assembly referring to "Gear
Shift and Select Shaft Assembly Removal and Installation" in
this section.
4) Tighten back up lamp switch (1) to specified torque.
Tightening torque
Back up lamp switch (b) : 23 N·m (2.3 kg-m, 17.0 lb-ft)
5) Check input shaft for rotation in each gear position.
6) Also confirm continuity of back up lamp switch in reverse
position using ohmmeter.
Transaxle Case Disassembly and Assembly
Disassembly
1) Remove differential gear assembly (1) from right case (2).
2) Remove VSS (3).
Advertisement
Table of Contents
