Table of Contents
Advertisement
7D-10 TRANSFER
a) Remove driven gear bearing outer race from left case (1)
using special tool.
Special tool
(A) : 09941-54911
b) Remove driven gear bearing outer race from right case (1)
using special tool.
Special tool
(A) : 09941-54911
Assembly
1) Install bevel gear shims and driven gear bearing outer races
to right and left cases.
NOTE:
If either or both the following part(s) is/are replaced,
adjust bevel gear shim referring to "Bevel Gear Shim
Adjustment" in this section.
• Driven gear bearing
• Bevel gear nut
• Bevel gear
• Reduction driven gear
2) Install reduction drive gear oil seal (1) to left case (2) using
special tool.
Special tool
(A) : 09913-75810
Transfer reduction drive gear oil seal installing depth
"a" : 1.5 – 2.0 mm (0.059 – 0.078 in.)
3) Fill grease to inside of oil seal about 3 g (0.11 oz), and apply
grease to oil seal lip.
"A" : Grease 99000-25010
Advertisement
Table of Contents
