Table of Contents
Advertisement
1
1
"a"
1
Front Door Window Inspection
Check deformity for glass run. If found defective, replace it with a
new one.
Front Door Window Regulator Removal and
Installation
REMOVAL
1) Remove door glass referring to "Front Door Window
Removal and Installation" in this section.
2) Disconnect power window motor lead wire at coupler and
loosen clamp, if equipped.
3) Loosen regulator mounting screws (1) and take out regulator
through hole (2) as shown in figure.
2
INSTALLATION
Reverse removal procedure to install window regulator noting the
following instruction.
• Apply grease to sliding and rotating portions of regulator.
Grease 99000-25010
• When installing glass, check that the top part of the glass
contacts the glass run evenly and that the glass moves up
"b"
and down smoothly.
If the glass is tilted with respect to the glass run, adjust
equalizer (1) of window regulator so that measurement "a"
and "b" are equal.
BODY SERVICE 9-7
Advertisement
Table of Contents
