Suzuki Ignis Service Manual page 3790

1
3
Transmitter Code Registration Procedure
NOTE:
• Three transmitter codes can be registered at the same
time.
• When the fourth transmitter code is registered, the old-
est one will be cleared automatically.
If transmitter or door lock controller is replaced with new one, reg-
ister code as follows.
1) Make sure that all doors are closed and ignition key is out of
ignition key cylinder
2) Open driver side door.
3) Turn ignition switch to ON position, and then remove ignition
key from ignition key cylinder within 10 seconds after that.
4) Push and release driver side door switch (1) at 3 times by
hand within 20 seconds after removing ignition key from igni-
tion key cylinder.
5) Turn ignition switch to ON position, and then remove ignition
key from ignition key cylinder within 10 seconds after that.
6) Push "UNLOCK" button (2) on transmitter (3) and confirm
that all doors are operated from lock to unlock.
2
With this, code registration is completed.
Power Door Mirror Switch Inspection
1) Disconnect negative cable at battery.
2) Pull out mirror switch from door trim.
3) Disconnect mirror switch lead wire coupler.
4) Check continuity between terminals at each switch position.
If any correct continuity is not obtained, replace mirror
switch.
Power door mirror switch specification
L
R
UP
DOWN
LEFT
RIGHT
WINDOWS, MIRRORS, SECURITY AND LOCKS 8D-35
a b c
d g
e f