Table of Contents
Advertisement
DTC B1073 – Side Sensor (Driver Side) Correspondence Abnormality
DTC B1075 – Side Sensor (Passenger Side) Correspondence Abnormality
WIRING DIAGRAM
1
2
1. From main fuse
2. Ignition switch
3. "AIR BAG" fuse
CAUTION:
• Be sure to perform "Air Bag Diagnostic System Check" before starting diagnosis according to flow
table.
• When measurement of resistance or voltage is required in this table, use a tester along with a cor-
rect terminal adapter from special tool (Connector test adapter kit).
• When a check for proper connection is required, refer to "Intermittents and Poor Connections" in
this section.
• If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.
DTC WILL BE SET WHEN
DTC B1073 or B1075:
Side sensor abnormal signal is detected by SDM.
TABLE TEST DESCRIPTION
DTC B1073 or B1075:
STEP 1 to 4: Check side sensor circuit in floor harness.
3
BLK/YEL
4. SDM
5. Side sensor (driver side)
6. Side sensor (passenger side)
"G75"
"L63"
RED
RED
"L34"
GRN/WHT
5
GRN/BLK
LT GRN/BLK
6
LT GRN
"L35"
BLK
7
AIR BAG SYSTEM 10B-51
"L21"
4
L21-32
IG
L21-17
SD+
L21-6
SD-
L21-16
SP+
L21-5
SP-
L21-31
GND
7. Ground for air bag system
Advertisement
Table of Contents
