Suzuki Ignis Service Manual page 3727

Rg413
Table of Contents

Advertisement

8B-8 LIGHTING SYSTEM
NOTE:
Item with the asterisk (*) is only for vehicle with the DRL system.
Terminal Wire color
A-1
RED/BLU
A-2
GRN/RED Power source circuit
*A-3
RED/YEL
A-4
YEL
A-5
YEL/BLK
*A-6
ORN
B-1
BLK
B-2
BRN
B-3
ORN
B-4
*B-5
GRN/RED Lighting switch lamp cir-
Circuit
Illumination control cir-
cuit
Tail light signal circuit
Rear fog light circuit
Front fog light circuit (if
equipped)
Daytime running light
(DRL) circuit
Ground circuit
Rear fog light switch cir-
cuit
Illumination control
switch signal circuit
cuit
Specification
Figure "A"
Lighting switch in positions other than OFF
and illumination control switch in maximum
position.
Figure "B"
Lighting switch in positions other than OFF
and illumination control switch in minimum
position.
10 – 14 V
10 – 14 V
Lighting switch in positions other than OFF
or with engine running, lighting switch in
OFF position.
Approx. 0 V
With engine stopping, lighting switch in OFF
position.
10 – 14 V
Lighting switch in ON position and rear fog
light switch pushed several times. The volt-
Approx. 0 V
age changes between the two shown val-
ues alternately at each time the rear fog
light switch is pushed.
10 – 14 V
Lighting switch in positions other than OFF
and front fog light switch pushed several
Approx. 0 V
times. The voltage changes between the
two shown values alternately at each time
the front fog light switch is pushed.
Approx. 0 V
Engine running and lighting switch in OFF
position.
10 – 14 V
Engine stopping or lighting switch in posi-
tions other then OFF.
1 Ω or less
10 – 14 V
Lighting switch in ON position and rear fog
(Non pushed)
light switch pushed several times. The volt-
age changes between the two shown val-
Approx. 0 V
ues alternately at each time the rear fog
(Pushed)
light switch is pushed.
Approx. 0 V
Lighting switch in positions other than OFF
and illumination switch in maximum posi-
tion.
4.5 – 4.9 V
Lighting switch in positions other than OFF
and illumination switch in minimum position.
Approx. 0 V
Lighting switch in positions other than OFF
or with engine running, lighting switch in
OFF position.
10 – 14 V
With engine stopping, lighting switch in OFF
position.
Condition

Advertisement

Table of Contents
loading

Table of Contents