Table of Contents
Advertisement
DTC B1063 – Side Sensor (Driver Side) Circuit Short to Ground
DTC B1064 – Side Sensor (Driver Side) Circuit Short to Power Circuit Or Open
DTC B1065 – Side Sensor (Passenger Side) Circuit Short to Ground
DTC B1066 – Side Sensor (Passenger Side) Circuit Short to Power Circuit or
Open
WIRING DIAGRAM
1
2
1. From main fuse
2. Ignition switch
3. "AIR BAG" fuse
CAUTION:
• Be sure to perform "Air Bag Diagnostic System Check" before starting diagnosis according to flow
table.
• When measurement of resistance or voltage is required in this table, use a tester along with a cor-
rect terminal adapter from special tool (Connector test adapter kit).
• When a check for proper connection is required, refer to "Intermittents and Poor Connections" in
this section.
• If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.
DTC WILL BE SET WHEN
DTC B1063 or B1065:
The voltage measured at side sensor (driver or passenger side) circuit is below a specified value for specified
time.
DTC B1064 or B1066:
The voltage measured at side sensor (driver or passenger side) circuit is above a specified value for specified
time.
3
BLK/YEL
4. SDM
5. Side sensor (driver side)
6. Side sensor (passenger side)
"G75"
"L63"
RED
RED
"L34"
GRN/WHT
5
GRN/BLK
LT GRN/BLK
6
LT GRN
"L35"
BLK
7
AIR BAG SYSTEM 10B-47
"L21"
4
L21-32
IG
L21-17
SD+
L21-6
SD-
L21-16
SP+
L21-5
SP-
L21-31
GND
7. Ground for air bag system
Advertisement
Table of Contents
