Table of Contents
Advertisement
WARNING:
For vehicles equipped with a Supplemental Restraint (Air Bag) System:
• Service on and around the air bag system components or wiring must be performed only by an
authorized SUZUKI dealer. Refer to "System Components and Wiring Location View" under "Gen-
eral Description" in air bag system section in order to confirm whether you are performing service
on or near the air bag system components or wiring. Please observe all WARNINGS and "Service
Precautions" under "On-Vehicle Service" in air bag system section before performing service on or
around the air bag system components or wiring. Failure to follow WARNINGS could result in unin-
tentional activation of the system or could render the system inoperative. Either of these two condi-
tions may result in severe injury.
• Technical service work must be started at least 90 seconds after the ignition switch is turned to the
"LOCK" position and the negative cable is disconnected from the battery. Otherwise, the system
may be activated by reserve energy in the Sensing and Diagnostic Module (SDM).
General Description ..................................... 7C1-2
Diagnosis ...................................................... 7C1-3
Diagnosis Table ......................................... 7C1-3
On-Vehicle Service....................................... 7C1-4
Clutch Cable Components ......................... 7C1-4
Clutch Cable Removal and Installation ...... 7C1-5
Clutch Cable Inspection ............................. 7C1-6
Clutch Pedal and Clutch Pedal Bracket
Components............................................... 7C1-7
Clutch Pedal Inspection ............................. 7C1-8
Clutch pedal height................................. 7C1-8
Clutch pedal free travel .......................... 7C1-8
Unit Repair Overhaul ................................... 7C1-9
Clutch Cover, Clutch Disc and Flywheel
Components............................................... 7C1-9
SECTION 7C1
CLUTCH
CONTENTS
Clutch Cover, Clutch Disc and Flywheel
Removal and Installation............................ 7C1-9
Clutch Cover, Clutch Disc and Flywheel
Inspection................................................. 7C1-11
Input shaft bearing ............................... 7C1-11
Clutch disc............................................ 7C1-12
Clutch cover ......................................... 7C1-12
Flywheel ............................................... 7C1-12
Clutch Release Mechanism Removal and
Installation................................................ 7C1-12
Clutch Release Mechanism Inspection.... 7C1-13
Clutch release bearing ......................... 7C1-13
Clutch release shaft ............................. 7C1-14
Tightening Torque Specification .............. 7C1-15
Required Service Material ......................... 7C1-15
Special Tool................................................ 7C1-16
CLUTCH 7C1-1
7C1
Advertisement
Table of Contents
