Table of Contents
Advertisement
10B-80 AIR BAG SYSTEM
Deployment/Activation Outside of Vehicle
When you intend to return the vehicle to service, deploy the air
bag (inflator) module(s) or activate seat belt pretensioner(s) out-
side of the vehicle.
1) Turn ignition switch to "LOCK" position and remove key.
2) Wear safety glasses during this deployment/activation pro-
3) Check that there is no open, short or damage in special tools
NOTE:
If faulty of seat belt pretensioner connector of adapter
cable (B) is found, replace it to spare connector (special
tool).
(B)
4) Short two deployment harness leads (1) together by fully
WARNING:
Deployment harness (A) shall remain shorted and not be
connected to 12 volts vehicle battery till you are ready to
deploy air bag module or activate seat belt pretensioner.
cedure.
(deployment harness (A) and adapter cable (B)). If any faulty
is found, do not use it and be sure to use new deployment
harness (A).
Special tool
(A): 09932-75030
(B): 09932-78331
seating one banana plug into the other.
Advertisement
Table of Contents
